TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 103 of 126
Figure 5-117 Figure 5-118 Figure 5-120 Figure 5-119 Install turbine assembly (A). Install coned part of snap ring driver (B) on end of turbine shaft. Install snap ring (C) on driver. Install knurled cap of snap ring driver (B). (Driver is part of kit—5120-572- 8663 (8356191)). Install bolt (A), and tighten it against cap (B) until snap ring (C) snaps into groove (D). Remove driver kit parts. (Bolt and cap are part of kit—5 120-572- 8663 (8356191)). Install lockup clutch back plate (A), seal ring (B), hook-type seal ring (C), and lockup clutch plate (D). NOTE Aline balance marks (E) on converter pump and back plate. Using lifting strap 4910-572-8608 (8356175) (A) and lifting eye 4910-673-8301 (10865773) (B), install pump cover assembly (C). Do not remove strap (A) and eye (B) at this time. NOTE Aline balance marks (D). 5-53