TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 99 of 336
TM 9-2520-238-34 REPAIR COOLING FAN RIGHT ANGLE DRIVE C (M113A3 FOV ONLY) — Continued 0016 00 13. Remove four cap screws (1), washers (2), packings (3), spindle assembly (4), and laminated shim (5) from housing (6). Discard packings and shim. NOTE Do not attempt to remove tapered roller bearing from shaft. The bearing and shaft are a matched set. If bearing of shaft is damaged, obtain a new shaft and bearing from supply. 14. Disassemble spindle assembly (4) as follows: a. Remove four cap screws (7) and washers (8). b. Remove shaft and bearing (9) with attached parts from bearing retaining plate (10). 15. Remove liquid sight indicator (11) and packing (12) from housing (6). Discard packing. 16. Remove pipe plug (13) from housing (6). 17. If inspection indicates identification plate (14) must be replaced, remove four drive screws (15) and identification plate from housing (6). Discard drive screws. Record identification data for use on new plate before discarding old plate. CLEANING CLEAN, INSPECT, AND REPAIR 1. Before inspection, repair, or assembly, clean all parts as described in (WP 0014 00). 2. Inspect all parts. Refer to (WP 0014 00) for general inspection procedures. See TM 9-214 to check bearings. Check wear limits page 0016 00-17. 3. Repair or replace defective parts. Refer to (WP 0014 00) for general repair procedures. 0016 00-5