TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 295 of 336
TM 9-2520-238-34 REPAIR SINGLE DISK PIVOT STEER BRAKE ASSEMBLY — Continued 0030 00 7. Lubricate new packing (4) with grease or petrolatum, and install packing, spacer (5), and new retaining ring (6) in release unit nut (7). 8. Lubricate new packing (8) with grease or petrolatum, and install new packing (8) on release unit nut (7). 9. Install release unit nut (7) in brake housing (9) using remover and replacer tool. NOTE Turn remover and replacer tool in the counterclockwise direction. 10. Deform one thread in release unit nut (7) securely in two places a minimum of 45 degrees from holes in unit. 11. Lubricate new packing (10) with grease or petrolatum, and install packing on release unit piston (3). 12. Place brake lining (11) on face of release unit piston (3). Using brake and clutch reliner, install piston with lining in housing (9) until piston is flush with outer edge of release unit nut (7). END OF TASK 0030 00-7/8 blank