TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 285 of 336
TM 9-2520-238-34 REPAIR STEERING CONTROL DIFFERENTIAL HOUSING — Continued 0029 00 5. Clean threads of lifting eye (1). Apply a light coat of antiseize compound to threads. 6. Install lifting eye (1) in housing (2) by turning lifting eye to the right. NOTE If resilient mounts were removed in page 0029 00-2, do Step 7. 7. Install resilient mounts (3). Use remover and replacer. 8. Install new grommet (4) in strainer (5). 9. Place two retainers (6) in housing (2). 10. Place strainer (5) in housing (2). Secure to two retainers (6) with eight washers (7) and cap screws (8). Install new lockwire (9) between screws on each retainer. 11. Install two new needle roller bearings (10) on right side housing (2). 12. Install two new needle roller bearings (10) on left side housing (2). NOTE If any alignment dowel pins were removed from housing in page 0029 00-2, do Step 13 and Step 14. 13. Install new alignment dowel pin (11) to protrude 21/32 inch (1.68 cm) from housing (2). 14. Install two new alignment dowel pins (12) to protrude 3/8 inch (.97 cm) from housing (2). WEAR LIMITS 1. See TM 9-214 to check bearings. 0029 00-5