TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 230 of 336
TM 9-2520-238-34 REPAIR OUTPUT SHAFT ASSEMBLIES — Continued 0024 00 C A U T I O N To prevent damage to encased oil seal, do not press seal beyond face of bore. After installation, seal must be flush with outer surface. 6. Install oil seal (1) in oil seal retainer (2). Use remover and replacer (WP 0033 00, Item 24) and hammer. NOTE If shoulder bolt(s) was removed in page 0024 00-2, do Step 7. 7. Install new bolt(s) (3) in base of shaft (4) with flat side of bolts toward shoulder. Use arbor press. 8. Install new piston ring (5) on piston ring retainer (6). 9. Install oil seal retainer (2) with oil seal (1) installed, new gasket (7), ball bearing (8), and retainer (6) with piston ring (5) on shaft (4). Use remover and replacer (WP 0033 00, Item 20) and arbor press. 0024 00-8