TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 228 of 336
TM 9-2520-238-34 REPAIR OUTPUT SHAFT ASSEMBLIES — Continued 0024 00 11. Remove gasket (11) and oil seal retainer (3) with encased oil seal (12) from output shaft (4). Discard gasket. 12. Tap out oil seal (12) from retainer (3) with hammer. Discard oil seal. NOTE If inspection indicates shoulder bolt(s) is damaged, do Step 13. NOTE If inspection indicates serrated lockring screw thread insert is damaged, do Step 7. 13. Remove bolt(s) (13) from base of output shaft (4). Use arbor press. CLEANING CLEAN, INSPECT, AND REPAIR 1. Before inspection, repair, or assembly, clean all parts of each output shaft assembly as described in (WP 0014 00). 2. Inspect all parts using general procedures described in (WP 0014 00). Check wear limits for minimum, maximum, and important clearances of new or rebuilt parts (page 0023 00-13). 0024 00-6