TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 163 of 336
TM 9-2520-238-34 REPAIR TRANSFER GEARCASE F — Continued 0019 00 28. Remove self-locking bolt (14), washer (15), and shouldered shaft (16) from gear (11). Discard bolt. 29. Remove secondary pump-drive gear (17) from housing (2). 30. Remove input gear (18) from housing (2). Separate bearing cone (19) and bearing cone (20) from gear. 31. As needed, remove bearing cup(s) from cover and housing (2) with me cchanical puller kit. Discard cup(s). CLEANING CLEAN, INSPECT AND REPAIR 1. Before inspection, repair or assembly, clean all parts (WP 0014 00). C A U T I O N Do not weld aluminum castings. If replacement of a bearing cup or cone is required, its associated cup or cone must be replaced. The housing and cover are machined as an unit and must be replaced as an assembly. 2. Inspect all parts. Refer to (WP 0014 00) for general inspection and repair procedures. Check parts for wear limits and important clearances page 0019 00-25. Repair or replace defective parts as needed. 0019 00-11