TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 151 of 336
TM 9-2520-238-34 REPLACE TRANSFER GEARCASE A, B, OR C WITH SERVICE SPARE TRANSFER GEARCASE E — Continued 0018 00 9. Apply antiseize compound to threads of two clean cap screws (17) at installation. Install bracket (14) on housing cover (18) with two key washers (19) and cap screws. Tighten cap screws to 144-180 lb-in (17-20 N•m) torque. Use torque wrench (WP 0033 00, Item 41). Bend tabs on key washers. 10. Install remote control lever (20) on engine disconnect actuator (21). NOTE Pin must bea press-fit into remote control lever on engine disconnect actuator. If necessary, ream the pin hole with a 5/16 inch (31 cm) drill bit. Do not ream hole larger than 0.313 inch (.6 cm). 11. Secure remote control lever (20) to actuator (21) by pressing or driving grooved pin (22) into pin hole. 0018 00-9 This is an internal gear and is not removed here. This is only shown as a reference for the pump installation. NOTE