TM-9-2520-238-34 Direct Support for M113 Family Major Assemblies Download
Page 129 of 336
TM 9-2520-238-34 REPAIR TRANSFER GEARCASES A, B, AND C — Continued 0017 00 NOTE Check that mating surfaces of second intermediate gear and primary pump-drive gear are clean. Alignment of gear teeth is not necessary. 6. Assemble helical gearshaft cluster (1). If dowel holes exist in second intermediate gear (2) and primary pump-drive gear (3), align holes in each gear. Secure gears together with new spring pin (4). Stake pin three equal places at both ends. If dowel holes do not exist in either gears (2) or (3), assemble gears and drill a 0.375 to 0.380 inch diameter hole using a 3/ 8 inch drill. Secure gear (2) and gear (3) together with new spring pin (4). Stake pin three equal places at both ends. 7. If removed, install bearing cone (5) and bearing cone (6) on helical gearshaft cluster (1). Install cluster in housing (7) meshing teeth of second intermediate gear (2) with first intermediate gear (8). 8. If removed, install bearing cone (9) and bearing cone (10) on output gear (11). Install gear in housing (7) meshing teeth with second intermediate gear (2). 0017 00-15