TM-9-2350-277-40&P Sustainment Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 73 of 472
21. Using .020 inch (.5 mm) shim stock and two 2 inch (51 mm) diameter hose clamps, compress three retaining rings (Figure 23, Item 28) on shaft (Figure 23, Item 29). Allow to set for 30 minutes. Remove both clamps and shim stock. Figure 23. Rear Housing Gasket – Installation. 22. Install new gasket (Figure 24, Item 18) on rear housing (Figure 24, Item 17). 23. Install front housing (Figure 24, Item 19) on rear housing (Figure 24, Item 17). 24. Install six screws (Figure 24, Item 21) and washers (Figure 24, Item 20) to secure front housing (Figure 24, Item 19) to rear housing (Figure 24, Item 17). Torque screws (Figure 24, Item 21) to 210-220 lb-in (24-25 N·m). Use torque wrench (WP 0069, Item 38). Figure 24. Front/Rear Housing – Reunion. 25. Install new encased oil seal (Figure 25, Item 15) in cover plate (Figure 25, Item 14). 26. Pump oil through lower oil passage (Figure 25, Item 39) until rear housing (Figure 25, Item 17) is full. 27. Lubricate new preformed packing (Figure 25, Item 16) and install on cover plate (Figure 25, Item 14). Install cover plate (Figure 25, Item 14) on rear housing (Figure 25, Item 17). TM 9-2350-277-40&P 0007 0007‐13