TM-9-2350-277-40&P Sustainment Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 223 of 472
9. Remove 12 screws (Figure 2, Item 9), 12 locknuts (Figure 2, Item 5), three dust caps (Figure 2, Item 35), connectors (Figure 2, Item 19), (Figure 2, Item 10), and (Figure 2, Item 33), and three gaskets (Figure 2, Item 18), (Figure 2, Item 7), and (Figure 2, Item 34) from faceplate (Figure 2, Item 3). Discard locknuts. 10. Remove four screws (Figure 2, Item 9), locknuts (Figure 2, Item 5), J7 connector (Figure 2, Item 30), and gasket (Figure 2, Item 18) from box (Figure 2, Item 8). Discard locknuts. 11. Remove two jamnuts (Figure 2, Item 25), lockwashers (Figure 2, Item 24), and connectors J9 lockwashers (Figure 2, Item 21) and J10 (Figure 2, Item 22) from box (Figure 2, Item 8). 12. Remove two jamnuts (Figure 2, Item 25), two lockwashers (Figure 2, Item 24), and connectors J113(Figure 2, Item 39) and J114 (Figure 2, Item 40) from faceplate (Figure 2, Item 3). 13. Remove four screws (Figure 2, Item 9), locknuts (Figure 2, Item 5), connector J22 (Figure 2, Item 38), gasket (Figure 2, Item 37), and dust cap (Figure 2, Item 36) from faceplate (Figure 2, Item 3). Discard locknuts. 14. Remove posts (Figure 2, Item 13) and (Figure 2, Item 11) from faceplate (Figure 2, Item 3). 15. Remove two locknuts (Figure 2, Item 17), two screws (Figure 2, Item 15), and two caps (Figure 2, Item 16) from faceplate (Figure 2, Item 3). Discard locknuts. 16. Remove six nuts (Figure 2, Item 23), six screws (Figure 2, Item 29), six washers (Figure 2, Item 28), two catch assemblies (Figure 2, Item 27), and two pads (Figure 2, Item 26) from box (Figure 2, Item 8). Figure 2. Connector – Removal. END OF TASK TM 9-2350-277-40&P 0033 0033‐3