TM-9-2350-277-40&P Sustainment Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 170 of 472
62. Route hoses (Figure 16, Item 99) and (Figure 16, Item 97) along sponson to elbows (Figure 16, Item 94) in floor plate. 63. Install one clamp (Figure 16, Item 96) on each hose (Figure 16, Item 99) and (Figure 16, Item 97). Connect hoses to elbows (Figure 16, Item 94) and secure with clamps (Figure 16, Item 96). 64. Install one clamp (Figure 16, Item 101) on each hose (Figure 16, Item 99) and (Figure 16, Item 97). Secure to seat bracket (Figure 16, Item 104) with two screws (Figure 16, Item 103), washers (Figure 16, Item 102), and nuts (Figure 16, Item 100). NOTE Do not kink hoses. 65. Install clamp (Figure 16, Item 110) on hoses (Figure 16, Item 99) and (Figure 16, Item 97). Secure to weldnut (Figure 16, Item 105) with screw (Figure 16, Item 108) and washer (Figure 16, Item 109). 66. Install batteries and retainers. See TM 9-2350-277-13&P. 67. Install one clamp (Figure 16, Item 96) on each second coolant pump hose (Figure 16, Item 107) and second engine hose (Figure 16, Item 106). Connect hoses to elbows (Figure 16, Item 94) under driver's floor plate. Tighten clamps. Figure 16. Driver's Floor Plate Hoses/Clamps – Installation. TM 9-2350-277-40&P 0024 0024‐14