TM-9-2350-277-34 Direct and General Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 577 of 820
TM 9-2350-277-34 INSTALL NON-SKID RAMP KIT (M1064A3 ONLY) — Continued 0085 00 NOTE All dimensions shown in the following illustration are in inches and metric equivalents. Dimension tolerances are ± 1/16 inch (2 mm), unless otherwise indicated. 9. Locate, drill, and thread mounting holes as explained in following illustration and text. 10. Place ramp non-skid plate on ramp to use as a template to locate five holes. Drill five holes with 27/64 inch (11 mm) drill. Tap holes 1/2-13 UNC-2B to at least 1 inch (3 cm) deep. Use screw threading set. 11. Place ramp door non-skid plate on ramp door to use as a template to locate four holes. Drill four holes with 27/64 inch (11 mm) drill. Tap holes 1/2-13 UNC-2B at least 1 inch (3 cm) deep. Use screw threading set. 12. Place new handle stop and new release bracket on ramp to use as template to locate five holes. Drill five holes with 5/16 inch (8 mm) drill. Tap holes 3/8-16 UNC-2B to at least 1 inch (3 cm) deep. Use screw threading set. 0085 00-3