TM-9-2350-277-34 Direct and General Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 424 of 820
TM 9-2350-277-34 REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064A3 ONLY) — Continued 0065 00 2. Remove headed pin (2). Retain pin. 3. Remove cylinder (3) from anchor (4). 4. Remove anchor (4) and all weld material from hull bottom plate. Discard anchor. MODIFY 1. Grind weld area level and smooth. 2. Locate center of first hole as shown. NOTE Drill all holes straight and at right angles to hull bottom plate. 3. Drill first hole with 7/16 inch (11 mm) diameter drill. Bottom plate is 1-1/8 inches (3 cm) thick. Do not break through. 4. Tap first hole with a 1/2-13UNC tap to a minimum thread depth of 7/8 inch (22 mm). 0065 00-2 Change 1