Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2350-277-34 Direct and General Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download

Page 364 of 820

TM 9-2350-277-34 REPAIR COMMANDER’S CUPOLA (M113A3, M1059A3, M1064A3, AND M58 ONLY) — Continued 0051 00 WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. NOTE Surface on seal marked BOND THIS SIDE should be glued to hull. 10. Apply adhesive to cleaned mating surface around vision block opening. Allow adhesive to become tacky. Install seal (25) on hull. 11. Install arm (22) and washer (24) in hull bracket. Secure with new spring pin (23). 12. Install thumbscrew (21) in arm (22). Deform first thread of thumbscrew to prevent easy removal. NOTE Do not drill deeper than length of drive screw. 13. Drill three new 3/32 inch holes close to old drive screw holes. Use new clip (19) for template. 0051 00-14 Change 2