TM-9-2350-277-34 Direct and General Maintenance Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 186 of 820
TM 9-2350-277-34 REPAIR/REPLACE ACCELERATOR STOP SUPPORT ASSEMBLY — Continued 0018 00 5. Use a machinist’s hammer and a cold chisel to remove two rivets (4) securing nut (5) to support. Remove nut. INSTALLATION NOTE To install nut (2) only, go directly to Step 4. 1. Position support assembly (1) on front bulkhead 4-11/16 inches (11.9 cm) from left edge of support to engine compartment bulkhead. Use straight edge to locate and scribe a line between mounting holes. WARNING Unsafe welding practices can cause serious injury from fire, explosions, or harmful agents. Allow only authorized personnel to weld or cut metals, and follow safety precautions in TM 9-237. Protective clothing and goggles must be worn; adequate protective equipment used, a suitable fire extinguisher kept nearby; and requirements of TM 9-237 strictly followed. NOTE Read (WP 0004 00) before welding. 2. Weld support assembly (1) to floor plate, using dimensions shown, in accordance with TM 9-237. Use electrode type 5356. 0018 00-2