TM-9-2350-277-20-5 Unit Maintenance Manual Volume 5 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 545 of 928
TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR INTERNAL CABLE ASSEMBLY (M1059A3 ONLY) 0760 00 THIS WORK PACKAGE COVERS: Removal (page 0760 00-1). Installation (page 0760 00-3). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0926 00, Item 65) M a t e r i a l s / P a r t s Gasket Locknut (4) Lockwasher (7) P e r s o n n e l R e q u i r e d Signal Support System Specialist 31U10 R e f e r e n c e s See your -10 TM 3-1040-283-10 TM 3-1040-283-20&P E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Circuit breaker CB1 OFF (TM 3-1040-283-10) Battery ground strap disconnected (WP 0337 00) Air pressure released from compressor reservoir (TM 3-1040-283-20&P) Inboard armor shield removed (WP 0771 00) Smoke generator assembly removed from bracket (WP 0755 00) REMOVAL WARNING Before you do any maintenance, discharge all capacitors to ground or electrical shock could injure personnel. NOTE Left and right cable assemblies are replaced the same way, except left side cable assembly has six clamps and right side has only one. Left side is shown. 1. Disconnect cable (1) from jack 1J3 (left) (2) or 1J4 (right) (3) on back of control panel (4). 2. Remove six screws (5), lockwashers (6), clamps (7) and cable (1) from hull. Discard lockwashers. 3. Remove connector (8) attached to cable (1) through access plate (9). 0760 00-1