TM-9-2350-277-20-5 Unit Maintenance Manual Volume 5 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 251 of 928
TM 9-2350-277-20-5 REPLACE FUEL PUMP TO BULKHEAD CONNECTION HOSE (M577A3 AND M1068A3 ONLY) — Continued 0692 00 INSTALLATION NOTE Flareless (compression) fittings are used on the fuel lines. When these fittings are first installed, a sleeve is crimped on the tube or hose end. Consequently, when tubes or hoses are replaced, new fitting sleeves are also required. 1. Install 10 clamps (1) on hose (2). 2. Route hose (2) through openings in hull cross members. Align 10 clamps (1) with hull weldnuts. Secure with 10 new lockwashers (3) and screws (4). 3. Install fuel hose (2) on fuel pump (5) and nipple (6). FOLLOW-THROUGH STEPS 1. Open heater fuel shutoff valve (see your -10). 2. Connect battery ground lead (WP 0338 00). 3. Bleed fuel line (WP 0679 00). 4. Start heater (see your -10). Check all fittings for leaks. Turn heater off. 5. Install floor plates (WP 0539 00) or (WP 0544 00). 6. Install heater duct (WP 0706 00). 7. Start engine (see your -10). 8. Raise and lock ramp (see your -10). 9. Stop engine (see your -10). END OF TASK 0692 00-3/4 blank