TM-9-2350-277-20-4 Unit Maintenance Manual Volume 4 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 535 of 884
TM 9-2350-277-20-4 REPLACE FLOOR PLATES (M1064A3 ONLY) 0543 00 THIS WORK PACKAGE COVERS: Removal (page 0543 00-1). Installation (page 0543 00-2). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0926 00, Item 65) M a t e r i a l s / P a r t s Adhesive Cushioning pad (2) Cushioning pad Cushioning pad Cushioning pad (3) Cushioning pad Locknut (2) Locknut Non-metallic seal (2) Non-metallic seal P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s See your -10 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Personnel heater floor duct removed, if installed. (WP 0706 00) REMOVAL 1. Remove screw (1) and washer (2) from guard (3). 2. Remove screw (4), washer (5), locknut (6), and guard (3) from hull. Discard locknut. 3. Remove eight eyebolts (7), one screw (8), and nine lined washers (9) from right front floor plate (10) and left front floor plate (11). 4. Remove two screws (12), lined washers (13), and rear floor plate (14) from carrier. 5. Remove two locknuts (15), washers (16), screws (17), and guard (18) from rear floor plate (14). Discard locknuts. 6. If necessary, remove two pads (19), three pads (20), and pad (21) from front crossmembers by scraping. 0543 00-1