TM-9-2350-277-20-4 Unit Maintenance Manual Volume 4 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 438 of 884
TM 9-2350-277-20-4 ADJUST RAMP LOCK (M113A3 AND M1059A3 ONLY) — Continued 0521 00 2. Check ramp-to-hull seal. Replace cracked, worn, or torn seal (WP 0514 00). 3. If seal looks all right, apply a heavy coat of white chalk to sealing lip of ramp seal. 4. Raise and lock ramp. Unlock and lower ramp (see your -10). 5. Check ramp for chalk transfer from seal to ramp surface. 6. If chalk is not evenly distributed, adjust ramp lock (Step 1). 7. If there is no chalk along bottom of ramp or if no contact shows on bottom of ramp, replace seal (WP 0514 00). ADJUSTMENT RAMP LOCK ADJUSTMENT NOTE All ramp adjustments must be done with the ramp down. Always adjust forward linkage first. 1. Lower ramp (see your -10). 2. Remove cotter pin (1) and headed pin (2) from clevis (3). Discard cotter pin. 3. Disconnect clevis (3) from link (4). 4. Swing ramp lock handle (5) forward. If catch (6) does not engage with striker (7), adjust catch (Step 5). If catch and striker adjustment is all right, go to Step 7. NOTE Install the same number of flat washers on each side of all four supports. 5. To adjust catch (6) and striker (7), remove eight screws (8) and key washers (9) from four supports (10). Discard key washers. Remove or add new flat washers (11), as required, to shim between supports (10) and hull top plate. 0521 00-2 Change 2