TM-9-2350-277-20-4 Unit Maintenance Manual Volume 4 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 179 of 884
TM 9-2350-277-20-4 REPAIR/REPLACE POWER PLANT REAR ACCESS PANELS 0439 00 THIS WORK PACKAGE COVERS: Removal (page 0439 00-1). Installation (page 0439 00-2). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0926 00, Item 65) M a t e r i a l s / P a r t s Cotter pin (7) Locknut (6) P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s See your -10 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) REMOVAL 1. Unscrew seven T-bolts (1). Remove upper and lower panels (2) and (3). NOTE Do Step 2 for M901A3, M1068A3, and M1064A3 only. Replace strap loops only if damaged. M901A3 and M1068A3 have two strap loops and M1064A3 has six strap loops. 2. Remove two screws (4), washers (5), locknuts (6), and strap loops (7) from upper panel (2). Discard locknuts. NOTE Do Step 3 for M901A3, M1068A3, and M1064A3 only. M901A3 and M1068A3 have one snap-fastener stud and M1064A3 has two snap-fastener studs. 3. Remove locknut (6), two washers (5), and snap-fastener stud (8) from upper panel (2). Discard locknut. 4. Bend back seal supports on panel to remove seals (9) and (10). 5. Remove seven cotter pins (11), T-bolts (1), washers (12), and clamps (13) from hull. Discard cotter pins. 6. Remove seven screws (15) and spacers (16) from hull. 7. Remove two locknuts (17), screws (18), and cover (19) from hull. Discard locknuts. 0439 00-1