TM-9-2350-277-20-4 Unit Maintenance Manual Volume 4 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 126 of 884
TM 9-2350-277-20-4 REPLACE PUSH-PULL CONTROL ASSEMBLY, BRACKET, LINKS, AND PINS (CABLE-ACTIVATED LOCK) — Continued 0429 00 8. Turn the steering wheel (7) left and right to insure the locking pin is not interfering with operation. 9. Measure the locking pin (2) to see if it is flush with the steering wheel housing (4). The locking pin must be flush and can have only a negative tolerance. It can be a maximum recess of 1/16 inch (1.6 mm). This measurement is maintained for all positions of the transmission controller except the SL position. WARNING With the transmission controller in any range except SL and if the locking pin is protruding from the steering wheel housing any amount, the steering wheel will not turn properly and death of personnel or damage of equipment may occur. 10. Loosen two screws (6) and adjust the bracket (3) until the locking pin is flush or maximum 1/16 inch (1.6 mm) recessed. Tighten two screws (6). 0429 00-14