TM-9-2350-277-20-3 Unit Maintenance Manual Volume 3 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 728 of 962
TM 9-2350-277-20-3 REPLACE TOW START CONTROL ASSEMBLY AND BEARING — Continued 0391 00 5. Install control lever (1) into bearing (2). Secure with clevis pin (3), two washers (4), and new cotter pin (5). 6. Install clevis pin (6) on control lever (1). Secure with two washers (7) and new cotter pin (8). 7. Install rear collar (9) with rear setscrew (10) onto cable end of cable assembly (11). Insert end of cable through mounting hole on clevis pin (6). Install front collar (12) with front setscrew (13) on cable assembly. 8. Push control handle to full in position. Move lever (1) until contact is made with surface of tow start button (14). Adjust tow start button (14). 9. Tighten setscrews (10) and (13). WARNING Sharp wire end can injure hands. Make sure wire (15) is doubled over as a safety measure. 10. Double wire (15) over itself 1/4 inch (6 mm) minimum, as shown. 0391 00-6 Change 1