TM-9-2350-277-20-3 Unit Maintenance Manual Volume 3 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 713 of 962
TM 9-2350-277-20-3 REPLACE TRANSMISSION RANGE CONTROLLER/BRACKET (USED WITH CABLE-ACTIVATED STEERING LOCK) — Continued 0387 00 INSTALLATION 1. Install bracket (1) on bulkhead. Secure with three screws (2), six washers (3), and three new locknuts (4). 2. Connect wiring harness (5) to controller (6). 3. Install four mounts (7) on bracket (1). Secure with four screws (8), new lockwashers (9), and washers (10). 4. Install controller (6) on four mounts (7). Secure with four screws (11), new lockwashers (12), and washers (13). NOTE Do not tighten jamnuts until all parts to the cable and mechanical steering lock are fully assembled and adjusted. 5. Remove nut (14) from push-pull assembly (15) and insert end of push-pull assembly into hole in bracket (16). Secure with nut (14) and new lockwasher (17). 6. Secure end of push-pull assembly (15) to controller arm (18) with pin (19), two washers (20), and new cotter pin (21). 0387 00-3