TM-9-2350-277-20-3 Unit Maintenance Manual Volume 3 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 492 of 962
TM 9-2350-277-20-3 NOTE The M58 does not use connector, bushing, and hardware only adhesive sealant on wiring harness in hull opening. To remove leads on M58, carefully cut adhesive sealant and pull harness into carrier. 32. Loosen nut (14) that secures circuit 21 (15), 22 (16), 24 (17), and 30 (18) leads with rubber bushing (19) in connector (20). Separate nut (14), washer (21), and rubber bushing (19) from connector. 33. Remove connector (20) and harness from top of hull. Pull harness into carrier. 34. Remove 12 screws (1), washers (2), clamps (3), and harness (4) from left side plate of hull. 0362 00-14 Change 2 0362 00 REPLACE REAR MAIN WIRING HARNESS (M113A3, M1059A3, AND M58) — Continued