Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2350-277-20-3 Unit Maintenance Manual Volume 3 M113A3 M577A3 M1064A3 M1068A3 M58 Download

Page 474 of 962

TM 9-2350-277-20-3 REPLACE TRANSMISSION CONTROLLER WIRING HARNESS — Continued 0361 00 10. Remove three screws (1), lockwashers (2), clamps (3), and wiring harness (4) from driver’s front hull. Discard lockwashers. 11. Disconnect wiring harness connector (6) from transmission control (5). 12. Disconnect transmission wiring harness (7) from bulkhead connector located inside power plant compartment. 13. Remove four screws (8), locknuts (9), and connector (10) from driver’s compartment bulkhead. Have helper assist. Discard locknuts. 14. Remove transmission controller wiring harness (11). INSPECT AND REPAIR 1. Check harness continuity. Replace bad harness. 2. Check leads. Replace frayed, cracked, or broken leads (WP 0382 00). 3. Check connectors. Replace cracked or broken connectors (WP 0382 00). INSTALLATION 1. Place transmission controller wiring harness (11) in position near mating connectors. 2. Install transmission controller wiring harness connector (10), four new locknuts (9), and screws (8) on driver’s compartment bulkhead. Have helper assist. 0361 00-4 Change 3