TM-9-2350-277-20-2 Unit Maintenance Manual Volume 2 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 78 of 790
TM 9-2350-277-20-2 PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), INCLUDING LUBRICATION INSTRUCTIONS — Continued 0155 00 ITEM NO. INTERVAL MAN- HOUR ITEM TO BE CHECKED OR SERVICED C R E W M E M B E R PROCEDURE EQUIPMENT NOT READY/ AVAILABLE IF: 3) Inspect drain plugs and oil for metal particles. If metal chips are found, notify direct support maintenance. 4) Clean and install the drain plug (WP 0452 00). 5) Fill each final drive with OE/HDO or OEA, as applicable, to bring oil level to a point between the FULL and ADD marks on gauge rod. Each final drive holds approximately 3 1/2 quarts. See Final Drive Lubrication Table (Table 4, page 0155 00-19). Oil is contaminated with metal chips or particles. RIGHT FINAL DRIVE FILLER TUBE FINAL DRIVE OIL LEVEL (CHECK AND FILL) 0155 00-58 Change 3 2) Remove drain plugs from final drive housing and drain oil into the container (WP 0452 00). D 1) Place a suitable container under final drive housing. b. Drain final drives every 150 hours/1500 miles or semi-annually. o e hydraulic fluid for OE/ HDO or OEA. Red dye has been added to some final drives to aid in detection of leaks. TE n t NO u o t ts ti bs u