TM-9-2350-277-20-2 Unit Maintenance Manual Volume 2 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 491 of 790
TM 9-2350-277-20-2 ADJUST ACCELERATOR LINKAGE — Continued 0214 00 3. Position upper accelerator pedal (1) against heel stop (2). Have helper assist. 4. Loosen jamnut (3) on throttle drag link (4). NOTE Turn rod end bearing to the left to lengthen throttle drag link, or to the right to shorten link during adjustment. 5. Turn fuel control shaft (5) to the right until center of connecting pin (6) is 1-1/16 to 1-1/8 inches (27 to 29 mm) from power plant bulkhead. (H) Hold functional shaft in position. NOTE Make sure free pin fit is made during adjustment. 6. Install throttle drag link (4), two washers (7), screw (8), and new locknut (9) on accelerator arm (10). Tighten jamnut (3). 0214 00-3