TM-9-2350-277-20-2 Unit Maintenance Manual Volume 2 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 389 of 790
TM 9-2350-277-20-2 REPLACE FUEL RETURN HOSES, TUBES, AND FITTINGS (M577A3 AND M1068A3 ONLY) 0196 00 THIS WORK PACKAGE COVERS: Removal (page 0196 00-1). Installation (page 0196 00-4). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0926 00, Item 65) M a t e r i a l s / P a r t s Sealing compound (WP 0928 00, Item 56) Wiping rag (WP 0928 00, Item 65) Grommet Lockwasher (13) P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s See your -10 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground lead disconnected (WP 0338 00) Map board removed (see your -10) Work tables removed (WP 0578 00) or (WP 0581 00 and WP 0582 00) Power plant lower rear access panel removed (WP 0439 00) Rear floor plates removed (WP 0539 00) or (WP 0544 00) REMOVAL NOTE Use wiping rag to wipe up any spilled fuel. 1. Disconnect auxiliary generator return hose (1) from tee (2). 2. Remove return tube (3) from elbow (4). 3. Remove cap (5) and elbow (4) from tee (2). 4. Remove three screws (6), lockwashers (7), and clamps (8) from weldnuts on right hull plate. Discard lockwashers. 5. Disconnect return tube (3) from tee (9) on fuel filler tube (10). 0196 00-1