TM-9-2350-277-20-2 Unit Maintenance Manual Volume 2 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 349 of 790
TM 9-2350-277-20-2 REPLACE FUEL SUPPLY HOSES, TUBES AND FITTINGS (M577A3 AND M1068A3 ONLY) 0193 00 THIS WORK PACKAGE COVERS: Removal (page 0193 00-1). Installation (page 0193 00-5). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0926 00, Item 65) M a t e r i a l s / P a r t s Sealing compound (WP 0928 00, Item 56) Wiping rag (WP 0928 00, Item 65) Grommet Locknut (4) Lockwasher (14) P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s See your -10 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground lead disconnected (WP 0338 00) Fuel tanks drained (WP 0178 00) Power plant rear access panel removed (WP 0439 00) Rear compartment floor plates removed (WP 0539 00) or (WP 0544 00) REMOVAL WARNING Fuel flowing over a metal surface causes static electricity. This will cause a spark unless the surface is grounded. NOTE Use wiping rag to wipe up any spilled fuel. 1. Disconnect personnel heater fuel hose (1) from shutoff valve (2), if installed. 2. Remove shutoff valve (2) and nipple (3) from tube (4). 3. Remove four screws (5) and lockwashers (6) that secure four ground leads (7), clamps (8), and two elbows (9) to four weldnuts (10). Discard lockwashers. 0193 00-1