TM-9-2350-277-20-2 Unit Maintenance Manual Volume 2 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 33 of 790
TM 9-2350-277-20-2 PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), INCLUDING LUBRICATION INSTRUCTIONS — Continued 0155 00 4) Install setscrews in hull armor mounting screw holes, as required. 5. FLUID LEAKS AND CHECKING FOR LEAKS a. GENERAL. Fluid leaks in hoses and fluid lines affect the carrier parts operation. The types and classes of leaks are given below. CLASS I Fluid Seepage is not great enough to form drops, but it is shown by wetness or color changes. CLASS II Fluid Leakage is great enough to form drops, but drops do not drip from the item being checked or inspected. CLASS III Fluid Leakage is great enough to form drops that fall from the item being checked or inspected NOTE You are allowed to operate equipment with minor water or oil leaks (Class I or II). You must consider how much fluid the item or system being checked or inspected can hold. When in doubt, notify your supervisor. Any fuel or Class III leaks will make the vehicle NOT READY/ AVAILABLE. b. CHECKING FOR LEAKS AFTER A MAINTENANCE TASK. After doing maintenance on a part which involves hoses or fluid lines, check for leaks. If leaks occur after you have done a replace or repair task, find the source of the leak. Correct the problem. Follow these procedures. 1) Do visual inspections to find the source of the leak. a) Check for cracks on housing or cover. b) Check that screws and any connections are not loose or overtight. 2) If you cannot see the source of the leak, check the items listed below. a) Check that preformed gasket is not bent, or pinched. b) Check machined surfaces for fit and cleanliness. c) If leak persists, notify supervisor. c. CHECKING FOR LEAKS USING CHALK TEST. Following replacement, repair, or adjustment of a ramp, door, hatch cover, access panel, or rubber seal, check for leaks by performing a chalk test. Use the following procedure: 1) Use chalk or chalk powder to coat area around seal. 2) Close ramp, door, hatch cover, or panel. 3) Open ramp, door, hatch cover, or panel. 4) Check for unbroken chalk line on mating surface. Where chalk does not stick to mating surface, there is a leak in the seal surface. 5) If a leak is found, perform adjustment to correct the problem. 6. WARM-UP ENGINE To warm up the engine for a maintenance or troubleshooting task, do the following: a. Cover air inlet grill. b. Start engine (see your -10). c. Release parking brake and apply service brake. 0155 00-13 Change 3