TM-9-2350-277-20-2 Unit Maintenance Manual Volume 2 M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 29 of 790
TM 9-2350-277-20-2 PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), INCLUDING LUBRICATION INSTRUCTIONS — Continued 0155 00 h. CASTINGS. WARNING Air pressure in excess of 30 psi (207 kpa) can injure personnel. Do not direct pressurized air at yourself or others. Always wear goggles. 1) Clean inner and outer surfaces of casting with cleaning compound (WP 0928 00, Item 19). Dry casting with compressed air. 2) Remove sludge and gum deposits with a brush. 3) Blow out all tapped holes with compressed air. i. BALL BEARINGS. Bearings require special cleaning techniques. See TM 9-214 for cleaning and maintenance procedures for ball bearings. j. OIL PASSAGES. 1) Make sure oil passages are not clogged. 2) Clean oil passages and break up any sludge or gum deposits. WARNING Air pressure in excess of 30 psi (207 kpa) can injure personnel. Do not direct pressurized air at yourself or others. Always wear goggles. 3) Flush oil passages with cleaning compound (WP 0928 00, Item 19). Dry parts with compressed air. k. OIL SEALS, ELECTRIC CABLES, AND FLEXIBLE HOSES. C A U T I O N Cleaning compound causes leather, rubber, and synthetic materials to become brittle. Do not use cleaning compound to clean seals, cables, and flexible hoses. 1) Clean seals, cables, and flexible hoses with general purpose detergent (WP 0928 00, Item 35) and water. Dry with wiping rag (WP 0928 00, Item 65). 0155 00-9 Change 3