TM-9-2350-277-10 Operator Manual M113A3 M577A3 M1064A3 M1068A3 M58 Download
Page 320 of 868
TM 9-2350-277-10 OPERATE AN/VAS-5 DRIVERS VISION ENHANCER (DVE)(M58 ONLY) Continued 0035 02 NOTE For all controls and indicators identified in this section, refer to Description and Use of Operator’s Controls and Indicators.(WP 0004 00) Before applying power to unit, ensure that the following control positions are as indicated in the following steps. Before operating the vehicle, ensure that the DVE azimuth and elevation controls are positioned in the locked straight-ahead and level 0 degree detent viewing positions. This will ensure that the driver is looking straight ahead when operating the vehicle. Drive ONLY in the straight-ahead and level 0 degree detent viewing position. 2. Unstow the driver’s commander’s display as required, by pulling display adjustment knobs out and positioning display in the viewing position. POWER VIDEO DISPLAY BRIGHTNESS POLARITY SENSOR LEVEL GAIN AUTO AUTO WHT-HOT BLK-HOT SENSOR ON VIDEO SENSOR SWITCH POWER ON/OFF SWITCH POLARITY WHT HOT / BLK HOT KNOBS PLUNGER SENSOR GAIN SENSOR LEVEL DISPLAY BRIGHTNESS CONTROL 3. Ensure azimuth and elevation controls are in straight-ahead and level 0 degree detent position. Ensure that the Azimuth Locking Knob is locked, securing the swivel plate in place. AZIMUTH CONTROL HANDLE ELEVATION CONTROL HANDLE AZIMUTH LOCKING KNOB 4. Set DVE POWER switch to OFF (down position). 5. Set VIDEO switch to SENSOR (up position). 6. Set POLARITY switch to WHT-HOT (up position). 7. With DISPLAY BRIGHTNESS control turned fully counterclockwise, rotate knob approximately 1/4 turn clockwise. 0035 02-2 Change 1