TM-9-2350-275-BD Battlefield Damage Assessment and Repair for M113 Family Download
Page 138 of 224
TM 9-2350-275-BD COMMUNICATIONS SYSTEM Procedural Steps (Cont): 7. CVC Helmet: a. Remove plastic earphone cushion and receiver retainer to gain access switch assembly. to the b. Connect four wires to white (switch position 6), black (1), shield (7), and red (4) wires. c. Hook the white wire to one of the inside jacks on the Soviet chest plate and the black wire to the other inside jack (Points A and B on chest plate figure). d. Hook the shield wire to one of the outside jacks and the red wire to the other outside jack. (Points C and Don chest plate figure). e. Reassemble helmet. If you can receive but not transmit, reverse the red wire leadand shield wire lead on the two outside jacks. 8. Operating procedures for the Soviet R-123M Transceiver: NOTE Operating procedures and steps are keyed to the following figure. a. Make sure the POWER SWITCH (23) and the DIAL LIGHT SWITCH (26) are in the off (down) position. b. Set the MODE SELECTOR SWITCH (3) to the Simplex (left) position. c. Make sure the ANTENNA LOADING CONTROL LOCKING NUT (8) is tightened (clockwise) until snug. 11-32