TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 747 of 788
TM 9-2350-261-34 REPLACE LOCKED-IN STUDS (M577A2 AND M1068 ONLY) 0102 00 THIS WORK PACKAGE COVERS: Removal (page 0102 00-1). Installation (page 0102 00-2). INITIAL SETUP: M a i n t e n a n c e L e v e l General Support T o o l s a n d S p e c i a l T o o l s Drill Set (WP 0104 00, Item 50) Extractor Screw Set (WP 0104 00, Item 17) General Mechanic’s Tool Kit (WP 0104 00, Item 19) Hacksaw (WP 0104 00, Item 23) Lockring Drive Tool (WP 0104 00, Item 15) Portable Electric Drill (WP 0104 00, Item 10) Screw Threading Set (WP 0104 00, Item 37) M a t e r i a l s / P a r t s Stud P e r s o n n e l R e q u i r e d Track Vehicle Repairer 63H10 R e f e r e n c e s WP 0106 00 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) REMOVAL 1. Use a hacksaw to cut off broken stud as close to mounting surface as you can. 2. If a locked stud with serrated lockring is being removed, punch center of remaining stud. Drill a pilot hole. NOTE Key-locked studs have pre-drilled pilot holes. 3. Use an extractor to remove stud. Discard stud. 0102 00-1