TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 532 of 788
TM 9-2350-261-34 REPLACE FIXED RESISTOR — Continued 0065 00 6. Use multimeter (16). Check resistance from circuit 7 terminal end (17) to strap end (18) of fixed resistor. 7. Multimeter should read 1.6 to 1.7 ohms. If reading is not in range, replace fixed resistor. INSTALLATION 1. If fixed resistor (11) is to be replaced, grind or cut sleeve (12) off of fuel tube (9). Discard sleeve. 2. Install fixed resistor (11) and new sleeve (12) on fuel tube (9). 3. Secure electrical lead (15) to fixed resistor (11) with screw (14) and nut (13). 4. Secure fixed resistor (11) to heater (3) with nut (10). 5. Secure fuel tube (9), flange (8), and tapping plate (7) to heater (3) with two screws (6). 6. Install end cover (5) on heater (3). Tighten four nuts (4). 7. Secure fuel control valve bracket (2) to heater (3) with two screws (1). FOLLOW-THROUGH STEPS 1. Install fuel control valve on coolant heater (WP 0062 00). 2. Install engine coolant heater in carrier (see your -20). END OF TASK 0065 00-2