TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 513 of 788
TM 9-2350-261-34 INSTALL ENGINE COOLANT HEATER KIT (M1064 ONLY) — Continued 0061 00 117. Replace standard generator belts with kit belts (see your -20). 118. Replace standard fan drive belts with kit belts (see your -20). 119. Adjust belts (see your -20). 120. Open heater fuel valve (1). FOLLOW-THROUGH STEPS 1. Install personnel heater (see your -20). 2. Lower power plant grille (see your -20). 3. Fill carrier cooling system (see your -20). 4. Connect battery ground lead (see your -20). 5. Bleed coolant heater fuel line (see your -20). 6. Start coolant heater (see your -10). Check for leaks and proper operation. Turn coolant heater off. 7. Install front floor plates (see your -20). 8. Install driver’s power plant access panel (see your -20). 9. Install power plant rear access panel (see your -20). 10. Close power plant front access door and raise trim vane (see your -10). 11. Raise and lock ramp (see your -10). 12. Stop engine (see your -10). END OF TASK 0061 00-23/24 blank