TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 470 of 788
TM 9-2350-261-34 INSTALL ENGINE COOLANT HEATER KIT (M577A2 AND M1068 ONLY) — Continued 0060 00 32. Place two clamps (10) on heat exchanger (11). 33. Install heat exchanger (11) in battery box (6). 34. Install two short hoses (12) on heat exchanger (11). Secure with two clamps (10). 35. Install two elbows (13) in two short hoses (12). Secure with two clamps (14). 36. Remove and discard two blank grommets from power plant bulkhead. 37. Install two grommets (15) in power plant compartment bulkhead. 38. Thread hose (16) and hose (17) through two grommets (15) in power plant compartment. 39. Pull two hoses (16) and (17) through two grommets (15) into personnel compartment to battery box (6). 40. Install two insulation tubes (18) on two hoses (16) and (17) at rear of power plant compartment. Secure with tape. 41. Install two insulation tubes (1) on two hoses (2) and (3) on forward side of power plant compartment rear bulkhead. 42. Install two insulation tubes (1) and two hoses (2) and (3) in power plant compartment. Secure with three clamps (4) and screws (5). 43. Install ends of insulation tubes (1) on two hoses (2) and (3). Secure with tape. 0060 00-8