TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 462 of 788
TM 9-2350-261-34 INSTALL ENGINE COOLANT HEATER KIT (M113A2, M901A1, AND M1059 ONLY) — Continued 0059 00 119. Replace standard generator belts with kit belts (see your -20). 120. Replace standard fan drive belts with kit belts (see your -20). 121. Open fuel tank shutoff valve (6). FOLLOW-THROUGH STEPS 1. Install personnel heater (see your -20). 2. Fill carrier cooling system (see your -20). 3. Connect battery ground lead (see your -20). 4. Bleed coolant heater fuel line (see your -20). 5. Start coolant heater (see your -10). Check that heater operates properly and does not leak. Turn coolant heater off. 6. Install rear and right front floor plates (see your -20). 7. Install driver’s power plant access panel (see your -20). 8. Install power plant rear access panel (see your -20). 9. Close power plant front access panel (see your -20). 10. Raise trim vane (see your -10). 11. Raise and lock ramp (see your -10). 12. Stop/shutdown engine (see your -10). END OF TASK 0059 00-28