TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 418 of 788
TM 9-2350-261-34 INSTALL ELECTRONIC EQUIPMENT HEATER KIT (M577A2 ONLY) — Continued 0058 00 16. Clean inside surface of intake hose (6) at one end only. Use solvent, cleaning compound. WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 17. Apply silicone adhesive sealant to cleaned inside surface of intake hose (6). 18. Insert a 1 inch (3 cm) silicone rubber hose (7) into intake hose (6) until end of hose (7) is flush with end of intake hose (6). 19. Place a 30 inch (76 cm) intake hose (6) with large end on intake elbow (5) and reduced end on heater intake duct (8). Secure both ends with two clamps (9). 20. Place exhaust duct (10) on exhaust elbow (4) and heater assembly exhaust outlet (11). 21. Install duct (10) in elbow (4) and exhaust outlet (11). Secure with two U-bolts (12), saddles (13), four washers (14), and four nuts (15). 0058 00-6