TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 414 of 788
TM 9-2350-261-34 INSTALL ELECTRONIC EQUIPMENT HEATER KIT (M577A2 ONLY) — Continued 0058 00 2. Place bracket (1) under platform (2). Secure with two screws (3) and nuts (4). 3. Remove nut (5), screw (6), and two washers (7) from platform (2). 4. Place bracket (8) on the end of platform (2). Secure with screw (6), nut (5), and two washers (7) that were removed in Step 3 above. Secure other end of bracket with screw (9) and nut (10). 5. Place saddle (11) and ground lead (12) under bracket (8). Secure with screw (13), nut (14), and three washers (15). Secure other end of saddle (11) with screw (13) and nut (14). 6. Install one clamp (16) in saddle (11) and one clamp (16) in bracket (1). WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 7. Apply a thin, even coat of primer and then sealing compound to external tapered pipe threads of heater fuel inlet nipple (1) and adapter (2). Do not apply primer or sealing compound beyond small end of threads. 0058 00-2