TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 39 of 788
TM 9-2350-261-34 INTRODUCTION HOW TO USE TROUBLESHOOTING — Continued 0005 00 Legend to Sample 1 TITLE This is the name of the procedure. 2 INITIAL SETUP This tells you the tools, materials/parts, personnel, references, and equipment conditions needed to do the procedure. 3 TASK STEPS These boxes give you step-by-step instructions. 4 REFERENCE LETTER This will send you to the correct block to continue with the troubleshooting procedure. 5 QUESTIONS This is the last step in YES blocks. The answer to this question will direct you to the next block. 6 ILLUSTRATIONS These help you locate and identify parts. Locating the Correct Troubleshooting Procedure (1) Component/carrier arrives at shop. (2) Read DA Form 2404. (3) Verify that the problem on DA Form 2404 exists. (4) Look up carrier symptom in Fault Symptom Index and go to that task. Perform the Troubleshooting Procedure (1) Make sure you have all items in INITIAL SETUP. (2 ) P erform req uired action(s) in Equ ipm ent C o nditio n. (3) Complete first block of task steps. (4) Refer to system schematic or diagram for system components, detail, and clarification. (5) Answer question at the bottom of the first block. (6) Follow YES or NO arrows to next block. (7) Move from block to block. Answer questions and follow instructions. You may be directed to: do further checks and tests on parts; go to another manual and do tasks; or go to another task. NOTE After completing the actions called for on another page or manual, return to the point in the troubleshooting procedure where you left off. (8) Locate fault and perform corrective action. (9) Check to make sure the fault is corrected, and there are no new faults. (10) Button up by installing items listed in Equipment Conditions after finishing the troubleshooting task. 0005 00-3