TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 376 of 788
TM 9-2350-261-34 REPLACE RAMP HYDRAULIC CYLINDER ANCHOR (M1064 ONLY) — Continued 0054 00 INSTALLATION 1. Install new anchor (1) with three new washers (2) and new screws (3). WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 2. TIGHTEN SCREWS (3) TO 54-59 LB-FT (73-80 N·M) TORQUE. Use torque wrench. Use adhesive primer as lubricant on threads and under screw heads. 3. Install cylinder (4) on anchor (1) with headed pin (5). Secure with new cotter pin (6). FOLLOW-THROUGH STEPS 1. Install mortar turntable and ring gear. See TM 9-1015-232-23&P. 2. Install mortar in carrier. See TM 9-1015-250-10. 3. Raise and lock ramp (see your -10). 4. Stop engine (see your -10). END OF TASK 0054 00-4