TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 365 of 788
REPAIR/REPLACE ACCELERATOR STOP SUPPORT ASSEMBLY — Continued ASSEMBLY NOTE To install nut (2) only, go directly to Step 4. 1. Position support assembly (1) on front bulkhead 4-11/16 inches (11.9 cm) from left edge of support to engine compartment bulkhead. Use straight edge to locate and scribe a line between mounting holes. WARNING Unsafe welding practices can cause serious injury from fire, explosions, or harmful agents. Allow only authorized personnel to weld or cut metals, and follow safety precautions in TC 9-237. Protective clothing and goggles must be worn; adequate protective equipment used, a suitable fire extinguisher kept nearby; and requirements of TC 9-237 strictly followed. 2. Weld support assembly (1) to floor plate, using dimensions shown, in accordance with TC 9-237. Use electrode type 5356. 3. Prepare and paint surface in accordance with TM 43-0139. 4. Position nut (2) on support (1). Secure with two rivets (3). 5. Install nut (4) and screw (5) into nut (2). 0052 00-3 0052 00 TM 9-2350-261-34