TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 330 of 788
TM 9-2350-261-34 REPLACE/REPAIR DRIVER’S LEVEL INDICATOR (M901A1 ONLY) — Continued 0043 00 NOTE Make sure all leads are tagged before removing. 2. Unsolder three electrical leads (4) from indicator switch (5) on indicator bracket (3). 3. Remove two screws (6), lockwashers (7), and level indicator (8) from plate nuts (9) on indicator bracket (3). Discard lockwashers. 4. Remove nut (10), lockwasher (11), marker (12), and switch (5) from bracket (3). Discard lockwasher. 5. Remove nut (13), lockwasher (14), terminal lug (15), ring spacer (16), lamp retainer (17), and lamp (18) from bracket (3). Discard lockwasher. 6. Drill out four rivets (19) and remove two plate nuts (9) from indicator bracket (3). Discard plate nuts and rivets. INSTALLATION NOTE Make sure carrier is on level ground. When installing driver’s level indicator, make sure cable is not pinched against housing. 1. Install new plate nuts (9) with four new rivets (19) on indicator bracket (3). 2. Install nut (13), new lockwasher (14), terminal lug (15), ring spacer (16), lamp retainer (17), and lamp (18) on indicator bracket (3). 3. Install nut (10), new lockwasher (11), marker (12), and indicator switch (5) on bracket (3). 4. Install two screws (6), new lockwashers (7), and level indicator (8) in plate nuts (9) on indicator bracket (3). 0043 00-2