TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 311 of 788
TM 9-2350-261-34 REPAIR TRACK TENSION ADJUSTER — Continued 0037 00 ASSEMBLY 1. If removed, press new sleeve bushing (14) in cylinder (3) from side opposite lubrication fitting (9). Use arbor press. 2. If removed, press new sleeve bushing (15) into plunger (2). Use arbor press. NOTE Install new packings (13) with sealing lips facing away from flange on piston (10). Lips face inside of cylinder. 3. Install five new packings (13), new bearing (12), and new retaining ring (11) on piston assembly (10). 4. Apply a light coat of engine oil to piston assembly (10) and to inside of cylinder (3). 5. Install piston assembly (10) in cylinder (3). 6. Install new retaining ring (8) in cylinder (3). Make sure it seats in groove. 7. Install new bearing (7) in cylinder (3). NOTE Install new wiper ring (5) with grooved edge facing out of cylinder toward retaining ring. 8. Install new packing (6), new wiper ring (5), and new retaining ring (4) in cylinder (3). 9. Apply a light coat of lubricating oil to plunger (2). 10. Install plunger (2) in cylinder (3). Maintain inward pressure on plunger and rotate clockwise until secure. 11. Install bleeder valve (1) and lubrication fitting (9) in cylinder (3). 0037 00-3