TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 298 of 788
REPAIR MULTIPIN CONNECTORS — Continued INSTALL RECEPTACLE NOTE If replacing lead, cut new wire from bulk supply. Measure original length, gauge, and type of wire. 1. Strip insulation from leads (3) to uncover just enough wire to fill well in contact (5). 2. Slide nut (1) over leads (3). NOTE Make sure leads pass through proper lettered hole in grommet. 3. Push leads (3) through grommet (4) and insert in new contacts (5). 4. Solder leads (3) in contacts (5) and press contacts into grommet (4). Check leads for continuity. 5. Align and install grommet (4) in receptacle (2). Secure with nut (1). REMOVE CABLE CONNECTOR NOTE Use same procedure for repairing single or multiple lead, and male or female cable connectors. 1. Loosen retaining nut (1) from plug (2). Slide nut back on cable (3). 2. Pull grommet (4) with contacts (5) from rear of plug (2). 3. Remove plug (2) and coupling nut (6) from cable (3). 4. Push leads of cable (3) into grommet (4) until contacts (5) are fully exposed on other side of grommet. Clip or de-solder leads from contacts. Discard contacts. 0034 00 TM 9-2350-261-34 0034 00-2