TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 22 of 788
TM 9-2350-261-34 HOW TO USE THIS MANUAL (cont) These and other new parts are listed under Materials/Parts in the INITIAL SETUP. GENERAL MAINTENANCE Cleaning, inspecting, checking for leaks, and similar procedures which apply to most WPs are found in CHAPTER 3, GENERAL MAINTENANCE PROCEDURES. Use these steps to clean and inspect any part being removed, repaired, or installed. Special cleaning will be covered in the WP stepS. HOW TO USE THE REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL) WITH THIS MANUAL The RPSTL TM 9-2350-261-24P gives the National Stock Number (NSN) required to order parts used in the maintenance WPs. To use the RPSTL to identify and order a part, do the following: In this manual, turn to the first page of the WP to be performed. Find Materials/Parts under INITIAL SETUP, and read the part(s) that need replacement. If required, find the illustrated part in the WP steps. Go to the RPSTL and find the same illustrated part. That part will have an item number assigned to it. Look this item number up in the listing for that figure. The NSN can be found in the National Stock Number and Part Number Index in the back of the RPSTL. If you inspect an item and find that it is damaged, go to the RPSTL and find the SMR code for the item. If the SMR code does not authorize you to repair the item, reassemble it and send it to the authorized level of maintenance. x