TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 165 of 788
TM 9-2350-261-34 REMOVE/INSTALL TRANSFER GEARCASE — Continued 0019 00 11. Connect differential oil hose (10) to elbow (11). 12. Install turnbuckle (3) on idler arm bracket (9). Secure with screw (8) and nut (7). NOTE When replacing generator drive belts, replace in matched sets only. NOTE There can be different generator components on transfer gearcase. Refer to TM 9-2350-261-20 for 200 amp generator maintenance components. 13. Install two generator drive belts (4) on generator pulley (5) and transfer gearcase pulley (6). NOTE Check alignment of generator pulley with transfer gearcase drive pulley. If necessary, position generator bracket until pulleys are aligned within 1/8 inch (3 mm). 14. Turn turnbuckle (3) to the right until belt deflection at midspan is 1/2 to 5/8 inch (13 to 16 mm) when measured with machinist rule. 15. Tighten locknut (1) on rod end (2). 0019 00-7