TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 144 of 788
TM 9-2350-261-34 REMOVE/INSTALL TRANSMISSION — Continued 0016 00 3. Position transmission on transfer gearcase. Turn transmission drive-shaft until transmission torque converter studs align with transfer gearcase drive plate holes. Have helper assist. 4. Apply a thin coat of antiseize compound to cleaned threads of 12 screws (2) and (3). NOTE Screws are different sizes. Each screw must be installed in the same place as it was removed. 5. Align transmission and air box drain can bracket (5) with transfer gearcase. Secure with ten short screws (2), two long screws (3 ), and w asher s ( 4) . Hav e h e lper (H) a ssi st . T IG H T E N EA C H S C R E W TO 252 -3 00 LB -IN (2 8- 34 N ·M ) TO R Q UE . U se to rqu e w ren ch. L OO SE N A ND R E T IG H T E N TO 252 -30 0 LB -IN (28-34 N·M) TOR QUE. U se torque wrench. 6. Secure converter studs to drive plate with six new locknuts (4). TIGHTEN NUTS TO 37-40 LB-FT (50-54 N·M) TORQUE. Use torque wrench. 0016 00-10